Mounting the Bike Handle
Mounting the Handlebar
5
4
3
1
2
Place the rubber liner (1) in the
N
clamp (2) and against the drive
tube (3).
Position rubber liner (4) on the drive
N
tube so that it lines up exactly with
the lower rubber liner.
Place the handle support (5) on the
N
rubber liner.
FT 250
9
8
6
2
Fit the handlebar (6) in the handle
N
support – the rubber handle (7)
must be on the left (viewed from the
engine).
Place the clamp (8) on the handle
N
support and handlebar.
Insert the screws (9) through the
N
holes in the parts and screw them
into the lower clamp (2) – do not
finally tighten yet.
Lining up the handlebar
7
Secure the handlebar (1) on the
N
drive tube (2) about 43 cm (17 in.)
(A) from the engine.
Line up the handlebar and tighten
N
down the screws firmly.
English
A
1
2
11