Table of Contents
Advertisement
English
Adjusting the Throttle Cable
A properly adjusted throttle cable is the
precondition for correct operation in the
starting throttle, idle and full throttle
positions.
Adjust the throttle cable only when the
machine is completely and properly
assembled.
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
1
2
Press down the trigger lockout (1)
N
and squeeze the throttle trigger (2)
(full throttle position) – this sets the
throttle cable correctly.
16
Mounting the Cutting Blade
Lay the power edger on its back so
N
that the blade mounting (1) faces
up.
5
6
4
2
3
Insert the stop pin (2) into the
N
hole (3) as far as stop – apply slight
pressure and turn back and forth
together with the thrust plate (4)
until the pin slips into position and
blocks the shaft.
Fit the combination wrench (5) on
N
the screw (6).
Loosen the screw clockwise (left-
N
hand thread) and take it out.
6
9
4
9
11
Remove the thrust washer (4).
N
Position the blade (9) on the thrust
N
plate (10).
WARNING
Collar (see arrow) must engage the
blade's mounting hole.
Fit the thrust washer on the
N
shaft (11) and block the shaft.
Fit the screw (6) in the shaft
N
counterclockwise and tighten it
down firmly.
FC 95, FC 110
10
Advertisement
Table of Contents
