Assembly - ProForm 725 TL 831.297763 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
a phillips screwdriver
1. Refer to the drawing on page 4 and identify the right
side of the treadmill. With the help of a second person,
carefully lay the treadmill on its right side; do not lay the
treadmill on its left side or the storage latch may be
damaged.
Firmly slide a Base Extension (76) into one side of the
Base (86). Using the Allen Wrench (89), tighten an
Extension Bolt (13) into the Base Extension and the Base.
While the treadmill is on its side, attach the other Base
Extension (not shown) in the same manner.
2. Attach six Base Pads (43) to the Base (86) and the Base
Extensions (76) in the indicated locations. Note: One
extra Base Pad may be included.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base (86) and the
Base Extensions (76) are resting on the floor.
Refer to HOW TO LOWER THE TREADMILL FOR USE.
Follow the instructions to lower the treadmill.
3. Cut the two Shipping Ties from the Handrails (61).
4. Remove the four Handrail Bracket Screws (15) from the
right side of the Frame (83). Position the right Handrail
Bracket (42) over the four screw holes in the Frame.
Loosely thread two of the Screws into the back holes of
the Bracket and into the Frame as shown.
Repeat this step on the left side of the Frame (83).
6
and scissors (not included) .
1
86
76
2
86
43
86
3
Shipping
Ties
61
4
15
42
83
,
13
89
76
76