Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches
wire cutters
, and rubber mallet
For help identifying the assembly hardware, see the drawings below. Note: The assembly hardware and other
small parts are packaged in separate part bags. If a part is not found in the part bags, check to see if the part
has been preassembled.
3/4" Screw (6)–12
1. With the help of a second person, carefully raise the
treadmill to the upright position as shown.
Insert one of the Extension Legs (106) into the treadmill
as shown. Make sure that the Extension Leg is turned so
the Base Pad (100) is on the bottom. If necessary, tip the
Uprights (82) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
Note: To prevent damage to the Upper Body Arms (35) if
they are moved too far sideways, the lower end of each
Upper Body Arm features a breakaway connector. If one
of the Upper Body Arms breaks away, simply press the
lower end back onto the Ball Joint (7 [not shown]).
1" Tek Screw (25)–4
1" Bolt (71)–2
and your own Phillips screwdriver
.
Internal Star
Washer (72)–2
1
35
6
1" Screw (86)
82
35
106
100
,
Advertisement
Table of Contents
