Configuring Vlan Interfaces (Gui) - Cisco WLC 5700 Series Interface Configuration Manual

Configuring VLAN Interfaces (GUI)

DETAILED STEPS
Command or Action
Step 1
show wireless interface summary
Example:
Step 2
show run int te1/0/1
Example:
Step 3
interface TenGigabitEthernet1/0/1
Example:
interface TenGigabitEthernet1/0/1
Step 4 switchport trunk allowed vlan 1-10
Step 5 switchport mode trunk
Step 6 nmsp attachment suppress
Step 7
end
Configuring VLAN Interfaces (GUI)
Before You Begin
You can configure VLANs in the controller using the web UI. To do this, you must follow the steps defined
in this module in the web UI.
SUMMARY STEPS
1. Choose Configuration > Controller > System > Interfaces > VLAN Summary.
2. Click the VLAN ID field in the table to view the details of the selected VLAN.
3. Enter the values.
4. Click Apply.
5. To create a new VLAN, click New.
6. To delete a VLAN, check the check box in the VLAN summary page, and click Remove.
DETAILED STEPS
Step 1 Choose Configuration > Controller > System > Interfaces > VLAN Summary.
This page displays all the VLANs and details of the VLANs in the controller.
Step 2 Click the VLAN ID field in the table to view the details of the selected VLAN.
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
66
Configuring Interface Groups
Purpose
Displays all the wireless interfaces in the controller.
Displays the running configuration available in the
controller.
Configures the 10-Gigabit Ethernet.
Configures the trunk port.
Configures the switch port mode as a trunk.
Returns to EXEC mode.
OL-32314-01