Audi TTS Coupe 2015 Owner's Manual page 92

Driver assist systems
ll'J
Not ready:
The indicator lamp lights up when
the system is switched on but not ready to inter­
vene. The causes for this can include the follow­
ing:
- There are no lane markings.
- The system cannot detect the relevant lane
markings (e.g. temporary markings for road
works or markings obscured by snow, dirt, rain
or adverse light).
- The vehicle's speed is below 65 km/h, the
speed at which the lane assist system is activa­
ted (the threshold may vary in different export
markets).
- The lane is narrower than 2.5 m or wider than
5.5 m.
- The bend is too tight.
- You have taken your hands off the steering
wheel.
Note
- Make sure that the camera window
Fig. 90
is not covered with stickers or sim­
q
ilar objects. Notes on cleaning q
- On vehicles for some export markets: once
the system is activated, it is "ready" each
time the ignition is switched on.
Infotainment display
Applies to: vehicles with Audi active lane assist
Fig. 91 Instrument cluster: active lane assist switched on
and in warning mode
You can use the controls on the multi-function
steering wheel to call up the active lane assist
page 18.
display q
90
Green line(s)
Red line(s)
(left or right
sides)
Grey line(s)
Driver messages on the infotainment display
Should the active Lane assist be deactivated auto­
matically, the indicator lamp on the display will
go out and one of the following messages will
appear:
Audi active lane assist: currently unavailable.
Camera view restricted due to surroundings.
This message is displayed when the camera is no
longer functional after the system has continu­
ously failed to detect the lane markings. This can
have the following causes:
page
253.
- The outside of the camera window q
Fig. 90
from this area of the windscreen.
- The inside of the camera window is misted up.
In this case, wait for the camera window to de­
mist before switching on the active lane assist
system again.
- Due to the road conditions, the system has not
been able to detect the lane markings for a
long period. Do not switch the active lane assist
system on again before the lane markings are
discernible.
Audi active lane assist: currently unavailable.
See owner's manual
A temporary fault is preventing the active lane
assist system from functioning. Try switching on
the active lane assist system again later.
Audi active lane assist: fault. See owner's man­
ual
Drive to a qualified workshop soon and have the
fault rectified.
Audi active lane assist: please take over steering
The active lane assist is switch-
ed on and ready to warn.
The active lane assist warns
you before you cross the lane
demarcation q
dition, the steering wheel vi-
brates slightly.
The active Lane assist is switch-
ed on but not ready to warn.
is dirty or frosted. Remove dirt or ice
Fig. 91.
In ad-
page 89,
�