Audi TTS Coupe 2015 Owner's Manual page 271

... Attach the tow-rope or the tow-bar only to the
towing anchorages provided for this purpose
qpage 269, qpage 269.
... Engage second or third gear before moving off.
... Press the clutch and hold the pedal down .
... Switch on the ignition.
... Once both vehicles are moving, release the
clutch.
... As soon as the engine starts, press the clutch
pedal and put the gear lever in neutral.
CD
CAUTION
When tow-starting the vehicle, do not tow it
further than 50 metres; otherwise the cata­
lytic converter could be damaged.
Front towline anchorage
Fig. 242 Front bumper: Cover cap
Fig. 243 Front bumper: Fitting the towline anchorage
The screw connection for the towline anchorage
is located behind a cover cap on the right side of
the front bumper.
... Take the towline anchorage out of the vehicle's
q page 259.
tool kit
0
N
... Firmly press the cap inwards
co
cover cap will be released from the bumper.
.....
\D
IJl
.....
\D
.....
q Fig. 242. The
... Screw the towline anchorage into the screw
connection as far as it will go
tighten it with the box spanner.
... Put the towline anchorage back in the tool kit
after use .
.&_
WARNING
If the towline anchorage is not screwed in as
far as the stop, there is a risk of the screw
connection shearing off during towing - risk
of accident!
Rear towline anchorage
Fig. 244 Rear bumper: Cover cap
Fig. 245 Rear bumper: Fitting the towline anchorage*
There is a screw connection for the towline an­
chorage on the right of the rear bumper.
... Take the towline anchorage out of the vehicle's
q page 259.
tool kit
... Firmly press the cap inwards
cover cap will be released from the bumper.
... Screw the towline anchorage into the screw
connection as far as it will go
tighten it with the box spanner.
... Put the towline anchorage back in the tool kit
after use.
Mobility
q Fig. 243 and
q Fig. 244. The
q Fig. 245 and
..,.
269