Windscreen Wipers - Audi TTS Coupe 2015 Owner's Manual

Windscreen wipers

Switching on the windscreen wipers
Fig. 46
Windscreen wiper lever
Move the windscreen wiper lever to the appropri­
ate position:
@ - Wipers off
(D- Intermittent wipe. Move switch@to the left
or to the right to increase or reduce the wiper de­
lay interval. If your vehicle is equipped with the
rain sensor*, the windscreen wipers will be acti­
vated automatically in the rain as long as the ve­
hicle has been moving faster than approx. 4 km/
h at least once. The higher the sensitivity level for
the rain sensor* is (i.e. the further to the right
the position of switch@
screen wipers react to moisture on the wind­
screen. You can deactivate the rain sensor mode*
on the infotainment system (this will activate the
intermittent wipe mode). Select the following on
the infotainment system:
left control button > Driver assist> Rain sensor >
off.
@-Slow wipe
@- Fast wipe
@ - Single wipe. If you hold the lever in this posi­
tion, the wipers will switch from slow continuous
wiping to fast continuous wiping after a while.
®-Wash/wipe.The screen is given an extra wipe
a few seconds later to remove any dribbles of wa­
ter (if the vehicle is moving and the temperature
is above approx. 4 °C).You can deactivate this
0
N
function by moving the lever to
co
within 10 seconds after the extra wipe. The ex-
.....
\D
IJl
.....
\D
.....
is), the sooner the wind­
button> Car>
!MENU!
position® again
tra-wipe function is activated again the next time
you switch on the ignition.
Headlight washers*. The headlight washer sys­
tem* only operates when the lights are switched
on. The headlights are automatically washed the
first time and every fifth time you move the lever
to position®·
.&_
WARNING
- The rain sensor* is only intended to assist
the driver. The driver is still obliged to man­
ually operate the windscreen wipers as re­
quired depending on visibility.
- Do not use water-repellent coatings on the
windscreen. In bad visibility conditions such
as light rain, low sun or when driving at
night these coatings can cause increased
dazzle, which is a serious safety hazard.
Such coatings can also cause the wiper
blades to judder.
- Poor visibility can cause accidents. Always
ensure that the wiper blades are in good
condition
q page 48, Changing the wind­
screen wiper blades.
CD
CAUTION
- In icy conditions, check that the wiper
blades are not frozen to the windscreen. If
the wiper blades are frozen to the wind­
screen when you switch on the windscreen
wipers, this could damage the wiper blades.
- Make sure you switch off the windscreen
wiper system (lever in position 0) before you
use an automatic car wash. This will avoid
inadvertent triggering of the wipers and
possible damage to the wiper system.
((ij}
Note
- The windscreen wipers are deactivated
when the ignition is switched off. You can
activate the windscreen wipers after switch­
ing the ignition on again by moving the
windscreen wiper lever to any position.
- Worn or dirty wiper blades can cause smear­
ing on the glass. This can also impair the ef­
fectiveness of the rain sensor*. Please check
the wiper blades regularly.
Lights and vision
______
47
..,.