ProForm PFSY69520 User Manual page 15

29. Wrap the High Cable (73) around a 4" Pulley
(35). Attach the Pulley and a Cable Trap (44) to
the top hole in the Pulley Bracket (91) attached to
the Leg Press Cable (76), with a 3/8" x 1 3/4"
Bolt (60) and a 3/8" Nylon Jamnut (63).
30. Route the High Cable (73) up through the next
slot in the Top Frame (1) and wrap the Cable
around a 4" Pulley (35) in the direction shown.
Attach the 4" Pulley (35) to the Top Frame (1)
with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers
(55), two 5/8" x 1/2" Bushings (42), and a 3/8"
Nylon Jamnut (63).
31. Route the High Cable (73) around a 4" Pulley
(35) and down through the indicated slot in the
Top Frame (1).
Attach the 4" Pulley (35) to the Top Frame (1)
with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers
(55), two 5/8" x 1/2" Bushings (42), and a 3/8"
Nylon Jamnut (63).
Let the High Cable (73) hang over the weight
stack; it will be attached in step 38.
32. Locate the Low Cable (72), which has a ball on
each end. Route the Low Cable through the slots
in the Leg Lever (29) and the Base (8).
Attach a 4" Pulley (35) inside the Leg Lever (29)
with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers
(55), two 5/8" x 1/2" Bushings (42), and a 3/8"
Nylon Jamnut (63).
Attach the 1/2" x 1 3/4" Bushing (94) inside the
bottom of the Leg Lever (29) with a 5/16" x 2 1/2"
Bolt (96), two 5/16" Washers (80), and a 5/16"
Nylon Jamnut (79). Press a 2" Square Inner Cap
(33) into the bottom of the Leg Lever. Note: It
may be easier to attach the 2" Square Inner
Cap if you pivot the Leg Lever upward.
29
35
44
73
63
76
30
35
63
55
42
31
35
63
55
42
73
32
8
42
55
63 79
15
91
60
73
1
55
54
1
55
42
54
29
54
55
42
96
80
94
80
35
72
33