ProForm PFSY69520 User Manual page 13

23. Remove the upper 3/8" x 3" Bolt (45) from the
Top Frame (1) and the Main Upright (3).
Route the High Cable (73) around a 4" Pulley
(35) and down through the indicated slot in the
Main Upright (3), as shown. Attach the Pulley
inside the slot with a 3/8" x 2 1/2" Bolt (54), two
3/8" Washers (55), two 5/8" x 1/2" Bushings (42),
and a 3/8" Nylon Jamnut (63).
Re-insert the 3/8" x 3" Bolt (45) and secure it with
a 3/8" Nylon Locknut (50). Note: The High Cable
(73) must be seated in the groove of the 4"
Pulley (35) before the Bolt is inserted.
24. Route the High Cable (73) under the welded tube
on the Press Frame (12) and around a 4" Pulley
(35) as shown. Attach the Pulley to the Press
Frame with a 3/8" x 8 1/2" Bolt (59) and a 3/8"
Nylon Locknut (50).
25. Wrap the High Cable (73) around a 4" Pulley (35).
Attach the Pulley inside the indicated slot in the
Main Upright (3) with a 3/8" x 2 1/2" Bolt (54), two
3/8" Washers (55), two 5/8" x 1/2" Bushings (42),
and a 3/8" Nylon Jamnut (63).
Wrap the High Cable (73) around another 4" Pulley
(35) in the direction shown. Route the High Cable
through the slot in the Main Upright (3). Attach the
Pulley to the Press Frame (12) with a 3/8" x 8 1/2"
Bolt (59) and a 3/8" Nylon Locknut (50).
23
Slot
50
1
55
63
24
Welded Tube
50
25
35
42
63 55
Slot
50
13
35
55
54
45
42
73
42
3
59
35
73
12
54
42
55
73
35
12
3
59