Pro-Form PFEL19010 User Manual page 7

5. Identify the Left Handlebar (6) and the Left Handlebar
Arm (5), which are marked with stickers. Attach the
Left Handlebar to the Left Handlebar Arm with two M8
x 45mm Bolts (50) and two M8 Nylon Locknuts (38).
Attach the Right Handlebar to the Right Handlebar
Arm (not shown) in the same way.
6. Apply a small amount of the included grease to the
left and right axles on the Upright (2).
Identify the Left Handlebar Arm (5), which is marked
with a sticker. Slide a Frame Spacer (48), a Handlebar
Spacer (47), the Left Handlebar Arm, and a Handlebar
Cap (46) onto the left axle on the Upright (2) as shown.
Slide an M10.5 Washer (55) onto an M8 x 25mm
Button Screw (56), and tighten the Button Screw into
the axle.
Attach the Right Handlebar Arm (7) in the same way.
7. Apply a small amount of grease to the axle on the left
Disc Crossbar (16). Slide the Left Pedal Arm (11) onto
the axle and attach it with an M8.5 Washer (35) and
an M8 Nylon Locknut (38).
Insert the Left Handlebar Arm (5) into the bracket on
the end of the Left Pedal Arm (11), and attach it with
a Pedal Arm Bolt Set (40).
Repeat this step to attach the Right Pedal Arm (not
shown).
Tighten the two M10 x 74mm Button Bolts (67).
5
6
50
6
46
55
56
7
5
40
11
40
7
38
5
Grease
48
47
2
5
67
16
Grease
35
38
7