Pro-Form PFEL19010 User Manual page 6

2. While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (9) to the Frame with two
M10 x 75mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
3. While another person holds the Upright (2) near the
Frame (1) as shown, connect the Upper Wire (44) to
the Reed Switch Wire (53).
Next, connect the Resistance Cable (45) to the
Lower Resistance Cable (65) in the following way:
• Refer to drawing A. Pull up on the metal bracket,
and insert the tip of the Resistance Cable (45) into
the wire clip on the Lower Resistance Cable (65)
as shown.
• Refer to drawing B. Firmly pull the Resistance
Cable (45) and slide it into the metal bracket on the
Lower Resistance Cable (65) as shown.
• Refer to drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Slide the Upright (2) onto the Frame (1); make sure
not to pinch the wires or cables. Attach the Upright
with two M10 x 74mm Button Bolts (67), two M10
Nylon Locknuts (33), and two M10 Split Washers (59).
Do not tighten the Button Bolts yet.
4. Connect the Upper Wire (44) to the wire on the
Console (23). Next, attach the Console to the Upright
(2) with four M4 x 12mm Screws (42).
Press the Resistance Knob (63) onto the Resistance
Control (45).
2
33
1
3
2
33
A
Metal
Bracket
45
65
4
Console
Wire
42
44
2
6
33
9
34
59
67
59
44
45
65
53
1
B C
45
45
65 65
63
23
45
42