Advertisement
6. Refer to the inset drawing. Insert the Weight
Tube (42) into the indicated hole in the Leg Lever
(21). Attach the Weight Tube with an M8 x 60mm
Bolt (48), two 8mm Washers (46), the 13.5mm
Spacer (47), and an M8 Nylon Locknut (45).
Press two 50mm Square Endcaps (24) into the
Leg Lever.
Refer to the inset drawing. Press a 25.4mm
Endcap (22) into the indicated end of the Weight
Tube. Press the Leg Lever Bumper (23) into the
other end of the Weight Tube.
Note: The above parts may have been
pre-assembled at the factory.
Lubricate the M12 x 95mm Bolt (32). Attach the
Leg Lever (21) to the Frame (4) with the Bolt and
the M12 Nylon Locknut (36). Do not overtighten
the Nylon Locknut.
7. Insert 25.4mm Square Endcaps (18) into the
ends of both Backrest Rails (10).
Attach the Backrest Rails (10) to the Backrest
(8) with four M6 x 40mm Bolts (27) and four M6
Washers (44). Do not tighten the Bolts yet.
Make sure that the Backrest Rails are turned
as shown.
Attach the Backrest Rails (10) to the tube on the
Frame (4) with the M10 x 190mm Bolt (30), two
10mm Washers (34), and an M10 Nylon Locknut
(35). Do not overtighten the Nylon Locknut.
Tighten the four M6 x 40mm Bolts (27).
8. Attach the Seat (7) to the Frame (4) with two M6
x 15mm Screws (29), an M6 x 65mm Bolt (41),
and three M6 Washers (44) as shown.
6
48
4
Lubricate
32
7
8
18
10
44
27
8
44
41
6
24
21
46
23
46
22
42
24
36
21
34
4
44
27
35
34
7
4
29
45
47
30
18
Hide quick links:
Advertisement
