Example Displaying The Details Of A Layer 2 Acl On A Service Instance - Cisco NCS 4200 Series Configuration Manual

Example Displaying the Details of a Layer 2 ACL on a Service Instance

Example Displaying the Details of a Layer 2 ACL on a Service Instance
The following sample output displays the details of a Layer 2 ACL called test-acl on a service instance.
Device# show ethernet service instance id 100 interface gig3/0/1 detail
Service Instance ID: 100
L2 ACL (inbound): test-acl
Associated Interface: Gig3/0/1
Associated EVC: test
L2protocol drop
CEVlans:
Interface Dot1q Tunnel Ethertype: 0x8100
State: Up
L2 ACL permit count: 10255
L2 ACL deny count: 53
The table below describes the significant fields in the output.
Table 6: show ethernet service instance Field Descriptions
Field
Service Instance ID
L2 ACL (inbound):
Associated Interface:
Associated EVC:
CEVlans:
State:
L2 ACL permit count:
L2 ACL deny count
Example Displaying the Details of Configured Layer 2 ACL
The following sample output displays the details of a configured Layer 2 ACL.
Device# show access-lists
Extended IP access list ip-acl
10 permit ip any any
Extended MAC access list mac-acl
permit any any vlan 10
Device#
Device#sh access-lists mac-acl
Layer 2 Configuration Guide for Cisco NCS 4200 Series
34
Layer 2 Access Control Lists on EVCs
Description
Displays the service instance ID.
Displays the ACL name.
Displays the interface details of the service instance.
Displays the EVC with which the service instance is
associated.
Displays details of the associated VLAN ID.
Displays whether the service instance is in an up or
down state.
Displays the number of packet frames allowed to pass
on the service instance by the ACL.
Displays the number of packet frames not permitted
to pass on the service instance by the ACL.