Configuring A Service Instance - Cisco ASR 900 Series Configuration Manual

ITU-T G.8032 Ethernet Ring Protection Switching
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
ethernet tcn-propagation G8032 to {REP | G8032}
Example:
Device(config)# ethernet tcn-propagation
G8032 to G8032
Step 4 end
Example:
Device(config)# end

Configuring a Service Instance

To configure a service instance, complete the following steps.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. service instance instance-id ethernet [evc-id]
5. encapsulation dot1q vlan-id [native]
6. bridge-domain bridge-id [split-horizon [group group-id]]
7. end
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Allows topology change notification (TCN) propagation from
a source protocol to a destination protocol.
• Source and destination protocols vary by platform and
Returns to user EXEC mode.
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Configuring a Service Instance
release.
63