Enabling Mac Security On An Evc Port Channel - Cisco NCS 4200 Series Configuration Manual

Configuring MAC Address Security on Service Instances and EVC Port Channels
Command or Action
Step 7
mac security
Example:
Device(config-if-srv)# mac security
Step 8 end
Example:
Device(config-if-srv)# end

Enabling MAC Security on an EVC Port Channel

Before You Begin
Note • Bridge-domain, xconnect, and Ethernet virtual circuits (EVCs) are allowed only over the port channel
• If you configure a physical port as part of a channel group, you cannot configure EVCs under that
SUMMARY STEPS
1. enable
2. configure terminal
3. interface port-channel channel-group
4. service instance id
5. encapsulation dot1q vlan-id
6. bridge-domain bridge-id
7. mac security
8. end
DETAILED STEPS
Command or Action
Step 1 enable
interface and the main interface.
physical port.
ethernet
Enabling MAC Security on an EVC Port Channel
Purpose
Enables MAC security on the service instance.
Returns to user EXEC mode.
Purpose
Enables privileged EXEC mode.
Layer 2 Configuration Guide for Cisco NCS 4200 Series
45