Use Cases Or Deployment Scenarios - Cisco NCS 4200 Series Configuration Manual

Use Cases or Deployment Scenarios

Use Cases or Deployment Scenarios
ELB is Supported with MAC Filter for UP-MEP Session
In the following scenario, ELB is supported using a MAC filter for UP-MEP session. If you starting ELB
with out MAC filter, the UP-MEP session will go DOWN.
enable
configure terminal
service instance 800 ethernet 800
encapsulation dot1q 800
service-policy input <NAME>
xconnect 2.2.2.2 880 encapsulation mpls
cfm mep domain <NAME> mpid 200
cos 7
ethernet loopback permit external
ethernet loopback permit internal
Router#ethernet loopback start local interface gi0/0/0 service instance 800 internal dot1q
800 destination mac-address f078.1685.313f timeout none
This is an intrusive loopback and the packets matched with the service will not
to pass through. Continue? (yes/[no]): yes
Router#show ethernet cfm maintenance-points remote
--------------------------------------------------------------------------------
MPID
Lvl
RDI
--------------------------------------------------------------------------------
220
0
-
Total Remote MEPs: 1
Layer 2 Configuration Guide for Cisco NCS 4200 Series
6
Domain Name
Domain ID
MA Name
EVC Name
Local MEP Info
CCI
CCI
800
800
MPID: 200 Domain: CCI MA: 800
Configuring Ethernet Dataplane Loopback
MacAddress IfSt
Ingress
Type Id SrvcInst
Age
f078.1685.313f Up
Gi0/0/0:(2.2.2.2, 880)
XCON N/A 800
0s
be able
PtSt
Up