Displaying The Mac Security Status Of A Specific Service Instance - Cisco NCS 4200 Series Configuration Manual

Displaying the MAC Security Status of a Specific Service Instance

Command or Action
Step 6
bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 200
Step 7 mac security sticky address mac-address
Example:
Device(config-if-srv)# mac security sticky
address 1111.2222.3333
Step 8
mac security
Example:
Device(config-if-srv)# mac security
Step 9 end
Example:
Device(config-if-srv)# end
Displaying the MAC Security Status of a Specific Service Instance
Perform this task to display the MAC security status of a service instance.
SUMMARY STEPS
1. enable
2. show ethernet service instance id id
3. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Layer 2 Configuration Guide for Cisco NCS 4200 Series
58
Configuring MAC Address Security on Service Instances and EVC Port Channels
Purpose
Binds the service instance to a bridge- domain instance
where bridge-id is the identifier for the bridge- domain
instance.
Sets up a MAC address to be declared as a sticky MAC
address on the service instance.
Enables MAC security on the service instance.
Returns to user EXEC mode.
interface type number
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
mac security