Stylus Scan Errors - Epson Stylus SCAN 2000 Service Manual

EPSON Stylus Scan 2000

1.5 Stylus Scan Errors

PRINTER
Error Cause
When one or more ink cartridges are almost
empty, the printer enters the low-ink state and
continues printing.
Ink out
When the cartridge is completely empty, the
printer indicates an ink-out error and stops
printing.
If the printer fails to properly load paper, it
Paper out
indicates a paper-out error.
If the printer fails to properly eject paper, it
Paper jam
indicates a paper jam.
If the printer detects that one of the ink
No ink cartridge cartridges is not installed, it indicates a no-ink-
cartridge error.
When the total amount of waste ink reaches
Maintenance
the limit, the printer indicates a maintenance
request
request and stops printing.
A carriage control or CG access error has
Fatal error
occurred.
NOTE: Do not re-install used ink cartridges. Doing so confuses the ink-level
detection function and may cause a serious problem in the printhead.
Product Description
SCANNER
Error
Solution
Fatal error
Install a new ink cartridge.
Load paper and press the
Load/Eject button.
Command error
Press the Load/Eject
button. If this does not
clear the error, remove the
paper by hand.
Install a new ink cartridge.
Replace the waste ink
pads.
Turn off the Stylus Scan
and turn it back on. If the
error does not clear,
service.
Stylus Scan Errors
Cause
• The lamp is broken.
• System breakdown.
• Scanner fails to eject the document.
• (Disposition)
Unidentified command detected.
(Disposition)
The scanner sent a NACK signal and is
waiting for the next command. If an incorrect
command or parameter is received, it is
disregarded and the previous value is
maintained.
Revision A
Solution
Turn off the Stylus Scan
and turn it back on. If the
error does not clear,
service.
Turn off the lamp and stop
operation. Set bit 7 of the
status byte.??
Send a correct command
to clear the error.
27