Removing The Scanner Mechanism - Epson Stylus SCAN 2000 Service Manual

EPSON Stylus Scan 2000

4.2.4 Removing the Scanner Mechanism

1. Remove the housing as described in "Front cover assembly" on page 90, "Rear cover"
on page 91, and "Upper cover" on page 92.
2. Remove the scanner cables from the cable clips as shown below.
3. Slightly pull out the circuit board tray as described in "Removing the Circuit Board
Tray" on page 96, and then remove the scanner-related cables from the B101 MAIN
board as described in "Removing the B101 MAIN Board" on page 97.
Disassembly & Assembly
4. Remove one ground screw (CBP 3x6) and three screws (CBP 3x6) securing the
scanner.
Remove the
cables from
these clips.
5. Slide the scanner slightly toward the CR motor and pull up to remove.
Disassembly Procedures
Remove two screws One screw
(CBP 3x8) (CBS 3x6)
Revision A
Ground connector
and screw
(CBS 3x6)
99