Table of Contents
Advertisement
8. Route the right Strap (119) under the right Roller
(67); make sure that the Strap is not twisted
and that it is routed under the Roller.
Attach the right Strap (119) to the right rear Glide
Belt Cover (63) with three M6 x 16mm Screws
(111) and a Strap Clamp (64); start all the
Screws, and then tighten them.
Repeat this step on the other side of the
elliptical.
9. Tip: Avoid pinching the wires. Insert the
Console Bracket (3) into the Upright (2). Attach
the Console Bracket with two M8 x 68mm
Screws (125).
Then, connect the wires from the Console
(4) to the Main Wire (141), the Right and Left
Control Wires (12, 13), and the Accelerometer
Wire (138).
10. Tip: Avoid pinching the wires. Attach the
Upper Neck Cover (17) to the Upper Bridge
Cover (16) with an M4 x 16mm Screw (98).
11. Make sure that all parts are properly tightened before you use the elliptical. Extra parts may be included.
Place a mat beneath the elliptical to protect the floor.
8
9
125
3
12
2
10
17
98
16
9
67
63
119
64
111
4
Avoid
pinching
the wires
141
13
138
125
Avoid pinching
the wires
Advertisement
Table of Contents
