NordicTrack NTEVEL19016.0 User Manual page 26

HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power cord.
Next, use a stan-
dard screwdriver
and pry the Outer
Disc (20) off
the Right Outer
Shield (23).
Locate the Reed Switch (56). Turn the Pulley (73) until
a Magnet (137) is aligned with the Reed Switch.
23
20
98
56 54
137
126
73
26
Next, remove the two M4 x 16mm Screws (98),
and then remove the Reed Switch Bracket (54).
Then, slightly loosen the two M4 x 10mm Clamp
Screws (126).
Then, reattach the Reed Switch Bracket (54) and slide
the Reed Switch (56) slightly closer to or away from
the Magnet (137). Plug in the power cord and rock the
Pulley (73) forward and backward so that the Magnet
passes the Reed Switch repeatedly. Repeat these
actions until the console displays correct feedback.
When the reed switch is correctly adjusted, remove
the Reed Switch Bracket (54), retighten the two
M4 x 10mm Clamp Screws (126), and reattach the
Reed Switch Bracket.
Then, reattach the outer disc to the right outer shield
and plug in the power cord.