Printek Mobile Thermal Printer MtP300 Series Operator's Manual page 34

Printer Configuration
WLAN Channel
Possible Values: 1* ... 14
Note that this feature is only available if the WLAN Type is set to Peer-to-Peer.
This feature sets the radio channel to be used when communicating in a Peer-to-Peer network. When in an
Infrastructure network, the radio channel is automatically assigned by the interface and Access Point.
WLAN SSID
Possible Values: any*,
Up to 16 characters of "0" through "9", "A" through "Z", "a" through "z",
This feature specifies the "name" of the network the printer will connect to. This allows communications to be
controlled, or routed to the appropriate nodes when multiple wireless networks are present. When set to "any",
the printer may connect to any available network(s).
To advance through the character positions, press the
position, press the Increment Button. The order of characters that may be selected is "0123456789
ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz".
WLAN WEP Bits
Possible Values: 0*, 64, 128
This feature specifies the level of Wired Equivalent Security to use. If set to "0", security is turned off. If set to
a"64" or "128" bit encryption level, a WEP Key must be entered that matches the key on the other nodes on the
network.
WEP Key 1
WEP Key 2
WEP Key 3
WEP Key 4
Possible Values: 10 or 26 character user specified hexadecimal string
Note that this feature is only available if WLAN WEP Bits is set to 64 or 128.
This feature specifies an encryption "key" or password that is used to encrypt/decrypt data on the network. If
WLAN WEP Bits is set to "64", a ten character hexadecimal string must be entered that matches the key on the
other nodes the printer will be communicating with. If WLAN WEP Bits is set to "128", a 26 character
hexadecimal string must be entered.
28
WLAN Channel
1
WLAN SSID
any
Advance Button. To change the character at the current
WLAN WEP Bits
0
Key1: 1234567890
– OR –
Key1: 0123456789
01234567890ABCDE