Printek Mt3 Quick Setup Instructions

Printek Mt3/Mt3B Quick Setup Instructions
Important:
1. You must charge the battery for 24 hours prior to the first use.
2. Maximum battery capacity is reached after completing a minimum of (3)
normal usage charge and discharge cycles.
3. Always use Genuine Printek Paper to ensure optimal performance.
4. To load paper, pull on the Paper Door Handle to open the Paper Door.
Drop in paper roll as shown in diagram. Close Paper Door.
5. To load battery, slide Battery Door Releases down, and then open the
Battery Door. Insert the Battery as shown in diagram. Close the
Battery Door, and then slide the Battery Door Releases back to the
locked position.
6. To unload battery, slide the Battery Door Releases down, and open
the Battery Door only half way. At this point the battery can be removed.
7. To perform the self test, press and hold the PAPER FEED button, and
then press the ON button.
8. Note: For additional detailed information, please refer to the Operator's
Manual. A copy of this manual can be downloaded by visiting
www.printek.com
SMART CARD READER
(OPTIONAL)
BATTERY DOOR RELEASE
BATTERY
P/N 91244
P/N 91245 (5-pack)
P/N 91246 (20-pack)
MAG CARD READER
(OPTIONAL)
IrDA WINDOW
BATTERY DOOR
ON/OFF BUTTON
PAPER FEED BUTTON
POWER ADAPTER INPUT
PAPER ROLL
P/N 91253 (5-pack)
P/N 91254 (35-pack)
P/N 91255 (Case of 200 rolls)
PAPER DOOR HANDLE
PAPER DOOR
POWER ON INDICATOR
(GREEN)
BATTERY CHARGING INDICATOR
(AMBER)
ERROR INDICATOR (RED) /
MCR READY INDICATOR (GREEN)
P/N #5688 Rev A