Belt Loop System - Printek Mobile Thermal Printer MtP300 Series Operator's Manual

6. You may continue to step through additional set up features by pressing the
7. When you have finished setting the parameters to match you host system, press the
until "Exit Menus" is displayed.
8. Press the Enter Button to save the changes and exit the Setup Mode.
9. Your printer is now configured and ready to communicate with your host system.
The belt loop system consists of two parts – a knob located on the bottom of the printer and a belt loop strap
with a click on connector
To use the belt loop system, slide your belt through the strap of the belt loop and then insert the knob located on
the bottom of the printer into the slot of the belt loop connector. Pull down on the printer until you hear a click.
The printer is now secure and can safely hang down beside your hip.
To release the printer, press in on the two latches on the sides of the connector and pull the printer and knob up
and clear of the slot.
Note: Do not force or pull the printer from the connector without pressing in on the two latches.

Belt Loop System

Getting Started
Enter Button.
Advance Button
7