Table of Contents
Advertisement
4
5
6
7
Configuring a Home Agent in gateway mode
When you configure the Home Agent in gateway mode, it receives GRE-encapsulated IP
packets from the Foreign Agent, strips off the encapsulation, and passes the packets across a
nailed WAN connection to the home network.
Figure 11-4. Home Agent in gateway mode
mobile clients
Note: To enable hosts and routers on the home network to reach the mobile client, you must
configure a static route in the Customer Premise Equipment (CPE) router on the home network
(not in the Home Agent). The static route must specify the Home Agent as the route to the
mobile client. That is, the route's destination address specifies the Framed-Address of the
mobile client, and its gateway address specifies the IP address of the Home Agent.
MAX 6000/3000 Network Configuration Guide
Set SAP Reply to Yes, and leave the default for UDP port:
Password=private
SAP Reply=Yes
UDP Port=5150
Exit the profile and, at the exit prompt, select the exit and accept option.
Open a Connection profile and configure an IP routing connection to the Foreign Agent.
For example:
Ethernet
Connections
any Connection profile
Station=foreign-agent
Active=Yes
Encaps=MPP
Dial #=555-1213
Route IP=Yes
Encaps options...
Send Auth=CHAP
Recv PW=foreign-pw
Send PW=home-pw
IP options...
LAN Adrs=10.65.212.226/24
Exit the profile and, at the exit prompt, select the exit and accept option.
MAX
Foreign Agent
WAN
RADIUS
Setting Up Virtual Private Networks
Configuring ATMP tunnels
CPE Router A
MAX
Home Agent
Internet
ATMP
CPE Router B
tunnel
home network
home network
11-15
Advertisement
Table of Contents
