Table of Contents
Advertisement
6
7
8
9
Configuring a connection with local servers only
In this example, the MAX unit connects to a local IPX network that supports both servers and
clients, and connects to a geographically remote network that supports one or more NetWare
clients. Figure 12-3 shows the setup.
Figure 12-3. A dial-in client that belongs to its own IPX network
In this example, Site A supports NetWare 3.12 servers, NetWare clients, and a MAX unit. The
NetWare server at Site A has the following configuration settings:
Name=SERVER-1
internal net CFC12345
Load 3c509 name=ipx-card frame=ETHERNET_8023
Bind ipx ipx-card net=1234ABCD
MAX 6000/3000 Network Configuration Guide
Exit the profile and, at the exit prompt, select the exit and accept option.
Open an IPX Route profile.
Set IPX RIP to None in the Connection profile, and configure a static route to the remote
server.
Set up a route to the remote NetWare server (SERVER-1). Use the following settings:
Ethernet
IPX Routes
SERVER-1
Server Name=SERVER-1
Active=Yes
Network=CFC12345
Node=000000000001
Socket=0451
Server Type=0004
Connection #=2
Note: The Connection # parameter in the IPX Route profile must match the number of
the Connection profile you configured for that site. If you specify the internal network
number of a server, make sure you specify values for Server Name and Server Type. If you
specify an external network, do not specify a value for Server Name or Server Type.
Exit the profile and, at the exit prompt, select the exit and accept option.
Site A
Ethernet
MAX
NET=1234ABCD
NetWare servers
and clients
Configuring IPX Routing
Configuring IPX routing connections
Site B
MAX
Net=1000CFFF
NetWare client
12-17
Advertisement
Table of Contents
