Lucent Technologies MAX 6000 Network Configuration Manual page 408

Hide thumbs Also See for MAX 6000:

Table of Contents

MAX 6000/3000 Network Configuration Guide

Priority level of the data stream. The three most significant bits of the

TOS byte are priority bits used to set precedence for priority queuing.

When you enable TOS, you can set the three most significant bits to

one of the following values (most significant bit first):

000—Normal priority

001—Priority level 1

010—Priority level 2

011—Priority level 3

100—Priority level 4

101—Priority level 5

110—Priority level 6

111—Priority level 7 (the highest priority)

Type of Service of the data stream. When TOS is enabled, you can set

TOS to one of the following values:

Normal—Normal service

Cost—Minimize monetary cost

Reliability—Maximize reliability

Throughput—Maximize throughput

Latency—Minimize delay

Note: The four bits adjacent to the most significant bits of the TOS

byte specify Type of Service of the data stream.

Direction in which the MAX supports TOS. If you set Apply To to

Input, the MAX sets TOS bits in packets received on the interface. If

you set Apply To to Output, the MAX sets TOS bits in outbound

packets. If you set Apply To to Both, the MAX set TOS bits for

incoming and outgoing packets.

Configuring IP Routing

Configuring WAN interfaces