Cisco XR 12000 Command Reference Manual page 260

show tech-support ppp
instance
location
node-id
all
rack
Command Modes
EXEC
Command History
Release
Release 3.9.0
Usage Guidelines
Tip This command can generate a very large amount of output. You may want to redirect the output to a file
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
This command generates PPP debugging information that can be useful for Cisco Technical Support
representatives when troubleshooting a router. See Obtaining Documentation and Submitting a Service Request
section on page iii in the Preface for Cisco Technical Support contact information.
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
252
Either a physical interface instance or a virtual interface instance as follows:
• Physical interface instance. Naming notation is rack/slot/module/port and a
slash between values is required as part of the notation.
◦ rack: Chassis number of the rack.
◦ slot: Physical slot number of the modular services card or line card.
◦ module: Module number. A physical layer interface module (PLIM) is
always 0.
◦ port: Physical port number of the interface.
Note In references to a Management Ethernet interface located on a route
processor card, the physical slot number is alphanumeric (RP0 or
RP1) and the module is CPU0. Example: interface
MgmtEth0/RP1/CPU0/0.
• Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?)
online help function.
(Optional) Specifies a node.
(Optional). Node ID. The node-id argument is entered in the rack/slot/module
notation.
(Optional) Specifies all locations.
(Optional) Displays the list of racks.
Modification
This command was introduced.
Tech-Support Commands
OL-28456-02