MSP-TS430L092
Settings of the MSP-TS430L092 Target Socket
Figure B-6
shows the PCB layout of the MSP-TS430L092 target socket. The following pinning is
recommended:
•
JP1 is write enable for the EPROM. If this is not set, the EPROM can only be read.
•
JP2 and JP3 connect device supply with boost converter. They can be opened to measure device
current consumption. For default operation, they should be closed.
Jumper JP1
Write enable for EPROM
Orient pin 1 of
MSP430 device
40
Hardware
Figure B-6. MSP-TS430L092 Target Socket Module, PCB
Copyright © 2009–2016, Texas Instruments Incorporated
Connector J3
External power connector
Jumper JP3
Open to measure current
SLAU278Y – May 2009 – Revised March 2016
Submit Documentation Feedback
www.ti.com