Advertisement
Brake Hoses and Pipes Inspection
Perform this inspection where these is enough light and
use a mirror as necessary.
• Check brake hoses and pipes for proper hookup,
leaks, cracks, chafing and other damage.
• Check that hoses and pipes are clear of sharp edges
and moving parts.
Repair or replace any of these parts as necessary.
CAUTION:
After replacing any brake pipe or hose, be
sure to carry out air purge operation.
Brake Fluid Replacement
Change brake fluid as follows.
Drain existing fluid from brake system completely, fill
system with specified fluid and carry out air purge
operation.
For air purging procedure, refer to "Air Bleeding of Brake
System: in Section 4A".
Brake Lever and Cable Inspection
1) Inspect brake cable for damage and smooth
movement.
Replace cable if it is in deteriorated condition.
2) Check tooth tip of each notch for damage or wear. If
any damage or wear is found, replace parking lever.
3) Check parking brake lever for proper operation and
S4RS0A0206017
stroke, and adjust it if necessary.
For checking and adjusting procedures, refer to
"Parking Brake Inspection and Adjustment: in
Section 4D".
Parking brake lever stroke
"a": 4 – 9 notches (with 200 N (20 kg, 44 lbs) of pull
pressure)
Clutch fluid Inspection
1) Check clutch system for evidence of fluid leakage.
Repair leaky point if any.
2) Check reservoir for fluid level referring to "Clutch
Fluid Level Inspection: in Section 5C".
If fluid is lower than minimum level of reservoir, refill
I4RS0A020008-
reservoir with specified brake fluid indicated on
reservoir cap.
S4RS0A0206018
S4RS0A0206019
I4RS0A020009-
Maintenance and Lubrication:
0B-8
I4RS0A020010-
S4RS0A0206020
I4RS0A410006-
Advertisement
