Siemens SIMATIC S7-1500 Manual page 52

Technical specifications
Isochronous mode
Isochronous mode (application synchronized until
terminal)
Bus cycle time (TDP), min.
Jitter, max.
Interrupts/diagnostics/status information
Diagnostics function
Interrupts
Diagnostic interrupt
Diagnostic alarms
Monitoring of supply voltage
Short-circuit
Group error
LED diagnostics display
RUN LED
ERROR LED
MAINT LED
Monitoring of supply voltage (PWR LED)
Channel status display
For channel diagnostics
Electrical isolation
Electrical isolation channels
Between channels
Between the channels and backplane bus
Between the channels and load voltage L+
Isolation
Isolation tested with
Ambient conditions
Ambient temperature in operation
Horizontal installation, min.
Horizontal installation, max.
Vertical installation, min.
Vertical installation, max.
Distributed operation
on SIMATIC S7-300
on SIMATIC S7-400
on SIMATIC S7-1200
on SIMATIC S7-1500
on Standard PROFINET Controller
52
6ES7553-1AA00-0AB0
Yes
250 µs; 375 µs, when all 4 channels are used
1 µs
Yes
Yes
Yes
Yes; thermal overload protection
Yes
Yes; green LED
Yes; red LED
Yes; yellow LED
Yes; green LED
Yes; green LED
Yes; red LED
No
Yes
No
707 V DC (type test)
0 °C
60 °C; note derating
0 °C
40 °C; note derating
Yes; via control and feedback interface
Yes; via control and feedback interface
Yes
Yes
Yes; via control and feedback interface
Technology Module TM PTO 4 (6ES7553-1AA00-0AB0)
Manual, 12/2016, A5E38896703-AA