Handset Power Up - AT&T Synapse SB67040 User Manual

Description Setup

Handset Power Up

The SB67040 Remote
To apply power to the SB67040 Remote Handset:
Figure. 6 Handset Power Connect
Figure. 7 Handset Battery Install
SB67040 Remote Handset User's Guide - Setup
Answer
Make Call Call
Handset uses a rechargeable 3.3v
Voice
Mail Hold/Park
nickel-metal hydride cell (NiMH) pack and comes with a battery charger..
1. Plug the power adapter into an electrical outlet not controlled
by a wall switch.
2. Plug the small end of the handset charger power adapter into
the jack on the underside of the charger
3. Route the cord through the slot as shown in Figure 6.
Note The power adapter is intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
1. Install the battery as shown in Figure 7. After installing the
battery, you can make and receive short calls.
2. Plug the battery securely into the plug inside the handset
battery compartment, matching the color-coded label.
3. Place the battery in the compartment with THIS SIDE UP facing
up as indicated.
4. Align the cover flat against the battery compartment cover,
then slide it upwards until it clicks into place.
23
Call
Transfer Conference Trouble Glossary