Air Shutter Adjustment - Lopi Berkshire MV Owner's Manual

28
10. Check the air shutter following the directions below.

Air Shutter Adjustment

Let the heater burn for fifteen minutes (make sure the media and glass are in place). The flames should be
yellow with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking flame.
Correct
Flames should be blue at the
base, yellow-orange on the top.
11. Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check the flame on low
position. The flames should burn off of each burner hole. If the heater does not work correctly, contact your Travis dealer
for a remedy.
12. Give this manual to the home owner for future reference and fully explain operation of this heater.
© Travis Industries
Finalizing the Installation
Not Enough Air
If the flames are too tall or sooty on the
ends, open the air shutter.
Gas Control Valve
10/2/17 - 1454
Too Much Air
If the flames are all blue and
short, close the air shutter.
Air Shutter Lever
(use screwdriver to adjust)
Right = Less Air (Closed)
Left = More Air (Open)
Berkshire MV