Aiphone AX-084C Quick Start Manual page 2

QUICK GUIDE TO CONFIGURING THE AX CENTRAL EXCHANGE UNIT:
The following describes the basics of the AX Setup Tool. Note that the CEU MUST be programmed
via PC in order for the system to work. Without programming, only Master 1 (M1) and Door 1 (D1)
will operate when connected to the CEU.
1) Central Exchange Unit
Step 1: Select the COM Port you
will be using. (Based on using
existing serial port or USB port
with converter. See Page 8 for
further information.)
Step 2: Select which model
CEU that you are using via the
dropdown box.
Step 3: If any AX-320C add-on
CEU's are included, click
"Connected" for each one.
2) Master Station
Step 1: Select the number of
masters being used, and
whether it is a video master or
audio only master.
3) Door Station
Step 1: Fill in location name of
each door station if desired.
(Not required. Names are not
stored in CEU.)
Step 2: Select Video, Audio, or
None, depending on which type of
door station is connected to each
input. (If setting remains on Video
when an audio-only door station is
used, the AX-8MV's LCD will
display a snowy picture when that
station is active.)
Step 3: Set call priority level by
selecting Priority or Normal from
the Call Level tab. Priority level
calls will have a faster call tone
and flashing LED on the master.
Page 2
Step 4: Set the door release contact to
either Normally Open or Normally
Closed by selecting N.O. or N.C. on the
DR Relay tab. The default is N.O.
(N.O.= Normally Open, N.C. = Normally Closed)