Matching Remote Handset & Control Box Id Code - FPI FireGenie Operating Instructions Manual

On-Time
8:00 am
Operates under Time Zone 1
Matching Remote Handset and Control Box ID Code
The Remote Control Handset has a set of unique ID codes that is pre-programmed into its
memory. This set of ID codes helps to differentiate one Remote Control Handset from
another so that only the control box with a matching ID code will respond to the
appropriate Remote Control Handset.
To match the control box, the following steps are to be followed:
1. Ensure the Remote is switched OFF.
2. Remove main power to the control box.
3. Reconnect main power to the control box.
4. Press and hold the PROG and FAN buttons simultaneously. The temperature
display will show the letters "LC" momentarily indicating the ID codes have been
transmitted.
5. The display will revert back to the normal off mode display.
6. Release both the PROG and FAN buttons.
The control box will only learn the Remote ID codes during the first 30 seconds after
power is applied and will ignore this special command from the Remote after the first 30
seconds.
NOTE: This must only be performed by a qualified installer.
TM
FPI FireGenie Remote Control Manual
Time Zone 1
1:00 pm
On-Time
Setting
Off-Time
2:00 pm
Time Zone 2
Operates under Time Zone 2 Setting
4:00 pm
Off-Time
Page 17