Setting The Program Mode - FPI FireGenie Operating Instructions Manual

It is recommended to unplug the unit while setting the programs.
In this mode, the user can program two On-Times and two Off-Times as well as the
Temperature settings for each day of the week. The PROG button is used to initiate the
programming mode. The "+" and "-" buttons are used to adjust the time and temperature
settings.
Note: The remote needs to be ON in order to set the Programs.
Follow the steps below to set the programs:
1) Programming the On-Time of Time Zone 1
Press and hold the PROG button for 2 seconds or more to initiate the
Programming mode.
The symbol "PROG 1" will flash to indicate the Remote is in Programming mode.
The On-Time for Time Zone 1 will also flash. The "+" and "-" buttons can be
used to adjust this time setting.
The LCD will show the current setting in Time Zone 1 for Monday:
TM
FPI FireGenie Remote Control Manual

SETTING THE PROGRAM MODE

Programming of Time Zone 1
Time Zone 1 On-Time
Page 11