Interfacing With Manual Control; Troubleshooting; Special Conditions In Program Mode - FPI FireGenie Operating Instructions Manual

INTERFACING WITH MANUAL CONTROL

When the unit is turned ON using the Remote Control and is later switched OFF from the
Manual Control Panel, the LCD on the Remote Control will still display as being ON
even though the unit is actually OFF. To have the unit function from the Remote Control
again you must press the ON/OFF button twice -- once to turn the remote OFF and then
again to turn the unit ON from the remote.
When the unit is turned ON from the Manual Control Panel, the LCD on the Remote
Control will display as being OFF even though the unit is actually ON. To have the unit
function from the Remote Control you will need to press the ON/OFF button once to turn
ON the remote.
If the remote control does not turn on:
 Ensure the batteries are correctly installed in the receiver.
 Check the batteries for replacement (2 x AAA alkaline).
When batteries are replaced, only the current of time and day will need to be reset. The
set program times are not affected.

Special Conditions in Program Mode

o If the On-Time of a Time Zone matches the Off-Time of the same Time Zone,
the Time Zone is disabled.
o If the Off-Time of the First Time zone crosses over to the On-Time of the
second Time Zone, the Off-Time of the first Time Zone will have precedent,
for example, if Time Zone 1 is programmed to end at 2:00 pm whereas Time
Zone 2 is programmed to commence at 1:00 pm, the following will occur:
Page 16

TROUBLESHOOTING

FPI FireGenie TM Remote Control Manual