Program Mode - FPI FireGenie Operating Instructions Manual

Program mode is selected by pressing and releasing the AUTO/MAN button until the
symbol "PROG" is shown on the LCD. The Remote will operate according to the settings
in the 2 Time Zones programmed by the user. Refer to Setting the Program Mode for
details.
Pressing and releasing the "+" or "-" button in this mode will cause the temperature
displayed on the LCD to change from showing the Room Temperature to show the Set
Temperature. The Set Temperature will remain displayed on the LCD for 5 seconds after
the button is released and then the display will revert to show the Room Temperature.
Program 1 mode
normal display
Pressing and releasing the PROGRAM button successively will allow the user to review
the programmed times for each day of the week.
If the Time Zones have not been programmed in the Remote, the display will show the
following:
Page 10

PROGRAM MODE

Room
Temperature
Set
Temperature
Programs have not been set.
When "+" or "-"
button is pressed
FPI FireGenie TM Remote Control Manual