Kit Preparation; Kit Assembly - Metra Electronics 95-7378B Installation Instructions

Kit Preparation

From the factory radio/vent panel:
1. Remove (4) screws securing the inner radio trim panel to the panel, and then
unclip and remove. (Figure A)
2. Attach the 95-7378B radio trim panel to the factory radio/vent panel, and then
secure using the factory hardware. (Figure A)
Continue to Kit Assembly
FACTORY RADIO/VENT PANEL
(Figure A)
REAR VIEW
OF
95-7378B
ISO DDIN radio provision
1. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure A)
2. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
3. Secure the completed assembly
into the dash using the factory
hardware, and then reassemble
the dash in reverse order of
disassembly.
3

Kit Assembly

(Figure A)