S120 Combi Power Modules
3.8 Electrical connection
3.8.3
Signal cables at the EP terminals
The shields of the signal cables at the EP terminals X21 and X22 are connected using the
shield clamp
involves the following steps:
● Mount the shield clamp at the S120 Combi using an SW3 wrench with a tightening torque
● Strip the insulation from the signal cables and crimp on end sleeves to the individual
● Connect the cores to the EP terminals (screw terminals)
● Connect the signal cable shields as shown below.
90
①
from the Completion Kit (Weidmüller: KLBÜ 4-13.5). The connection
of 1.8 Nm
cores
Figure 3-20
Signal cables connected with the correct shield support
SINAMICS S120 Combi
Manual, Edition 07/2012, 6SL3097-4AV00-0BP3