Terminals - Siemens SIPROTEC 5 Series Hardware Description

Electronic Modules
3.1 Power-Supply Modules of the Modular Devices
LEDs of the RJ45 Terminals
The light-emitting diodes (LEDs) signal the operating state of the communication connection. The operating
states are explained in the following table:
COM Link (RJ45) Signal
LED 1
LED 2
3.1.4.2

Terminals

Overview of Terminals
[dwcb202p-030211-01.tif, 2, --_--]
Figure 3-10
(1) 2-pole terminal to connect power supply
(2) LED: Power On
(3) COM link
(4) Plug-in module position M (for measuring-transducer modules only – equipped in this example
with an ANAI module)
(5) Plug-in module position N (for measuring-transducer or communication modules)
(6) Plug-in module position P (for measuring-transducer or communication modules – equipped in
this example with an ETH-BA-2EL module)
(7) Protective grounding terminal
The Ethernet connection to the base module is established at the COM link terminal.
The 2-pole voltage terminal is used for the external power supply (see
52
CL2_LED0_N
CL3_LED0_N
CB202 – Terminals
Color Operating State
Yellow Flashes when a communication module is inserted in
plug-in module position P.
Green Flashes when a communication module is inserted in
plug-in module position N.
Figure 3-12).
SIPROTEC 5, Hardware Description, Manual
C53000-G5040-C002-C, Edition 10.2017