Chapter 2. Best Practices For Troubleshooting; Record Access Information; Access Information For Your System - IBM Storwize V7000 Maintenance Manual

Chapter 2. Best practices for troubleshooting

Troubleshooting is made easier by taking advantage of certain configuration
options and ensuring that you have recorded vital information that is required to
access your system.

Record access information

It is important that anyone who has responsibility for managing the system know
how to connect to and log on to the system. Give attention to those times when the
normal system administrators are not available because of vacation or illness.
Record the following information and ensure that authorized people know how to
access the information:
v The management IP addresses. This address connects to the system using the
v The service IP address of the node canisters on the control enclosures is used
v The system password for user superuser. The password is required to access the
© Copyright IBM Corp. 2010, 2011
management GUI or starts a session that runs the command-line interface (CLI)
commands. The system has two Ethernet ports. Each port can have either an
IPv4 address or an IPv6 address or both. Record this address and any limitations
regarding where it can be accessed from within your Ethernet network.
only in certain circumstances. The service IP address connects to a node canister
in the control enclosure. Access to the address is sometimes required if the
canister has a fault that stops it from becoming an active member of the system.
Each of the two node canisters can have a service IP address that is specified for
Ethernet port 1. Each address can have either an IPv4 address or an IPv6
address or both. Ensure that the address specified for each node canister is
different.
system through the service IP address. The authentication of superuser is always
local; therefore, the user ID can be used when a remote authentication server
that is used for other users is not available.
Table 16. Access information for your system
Item
The management IP address
for the GUI and CLI
The management user ID
(the default is admin)
The management user ID
password (the default is
admin)
The control enclosure
management IP address
Control enclosure service IP
address: node canister 1
Control enclosure service IP
address: node canister 2
The control enclosure
superuser password (the
default is passw0rd)
Value Notes
19