IBM Storwize V7000 Maintenance Manual page 54

Create cluster command
Use this command to create a storage system.
Syntax
Parameters
-clusterip
-gw
-mask
-clusterip_6
gw_6
prefix_6
name
Description
This command creates a storage system.
This command calls the satask mkcluster command.
Query status command
Use this command to determine the current service state of the node canister.
Syntax
Parameters
None.
Description
This command writes the output from each node canister to the USB key.
This command calls the sainfo lsservicenodes command, the sainfo
lsservicestatus command, and the sainfo lsservicerecommendation command.
38
Storwize V7000: Troubleshooting, Recovery, and Maintenance Guide
satask mkcluster -clusterip
satask mkcluster -clusterip_6
(Required) The IPv4 address for Ethernet port 1 on the system.
(Required) The IPv4 gateway for Ethernet port 1 on the system.
(Required) The IPv4 subnet for Ethernet port 1 on the system.
(Required) The IPv6 address for Ethernet port 1 on the system.
(Required) The IPv6 gateway for Ethernet port 1 on the system.
(Required) The IPv6 prefix for Ethernet port 1 on the system.
(Optional) The name of the new system.
sainfo getstatus
ipv4
-gw ipv4 -mask
ipv6
-gw_6 ipv6 -prefix_6
ipv4 -name cluster_name
int -name cluster_name