Panasonic KX-NS8290 Installation Manual page 9

•
Do not install the system in the following locations:
–
In direct sunlight and hot, cold, or humid places. (Temperature range: 0 °C to 40 °C)
–
Areas where sulphuric gases may be present, such as near thermal springs.
–
Near devices that generate high frequencies, such as sewing machines or electric welders.
–
Locations where other objects will obstruct the area around the Trunk Adaptor. Be especially careful
to leave at least 5 cm to the sides of the Trunk Adaptor for ventilation.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Do not bundle cables that are connected to the Trunk Adaptor with the AC power cords of machines located
nearby.
•
To prevent malfunction, deformity, overheating, rust, and discolouration, do not install or place equipment
in the following types of locations:
–
Locations where air ventilation is poor.
–
Locations that may be exposed to sulphurous gas, such as near hot springs.
–
Near devices that emit heat, such as heaters.
–
Near devices that emit electromagnetic noise, such as radios or televisions.
–
Near devices that emit high-frequency noise, such as sewing machines or welders.
•
The Trunk Adaptor and the cables should never be placed near or over a radiator or other heat source.
•
The Trunk Adaptor should not be placed outdoors (use indoors).
•
The Trunk Adaptor should not be placed near high-voltage equipment.
•
The Trunk Adaptor should be kept free of dust, moisture, high temperature (more than 40 °C), low
temperature (less than 0 °C), and vibration, and should not be exposed to direct sunlight.
•
Before touching the product, discharge static electricity by touching ground or wearing an earthing strap.
Failure to do so may cause the Trunk Adaptor to malfunction due to static electricity.
•
When relocating the equipment, first disconnect the telecom connection before disconnecting the power
connection. When the unit is installed in the new location, reconnect the power first, and then reconnect
the telecom connection.
•
Make sure that the surface behind the Trunk Adaptor is not made of wood.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
When mounting the Trunk Adaptor on a wall, be sure to run the cables down the side of the Trunk Adaptor.
Do not run the cables down the front of it.
•
When the Trunk Adaptor is placed on a desktop, make sure that the Trunk Adaptor is placed as indicated
in "3.2.5 Placing the Trunk Adaptor on a Desktop". Do not place it on its side or upside down.
•
When placing the Trunk Adaptor on a desktop, be sure to run the cables on the side of the Trunk Adaptor.
Do not run the cables on top or under it.
•
It is strongly recommended to use SSL encrypted communication when the PC is accessing the Trunk
Adaptor via the Internet. To use SSL encryption, routers must have a port set up for https communication.
•
Avoid using the same AC outlet for computers and other office equipment, as noise generated by such
equipment may hamper system performance or interrupt the system.
CAUTION
1.1 For Your Safety
Installation Manual 9