Chart Setup - Raymarine GPM400 Reference Manual

5.4

Chart setup

Navionics cartography comes pre-installed on your system. You
can also use Navionics chart cards: in that case, the system uses
whichever cartography is the latest.
To suit your particular requirements, you can configure how the
Chart application displays cartographic data.
There are three ways you can change chart settings:
• Chart Setup Menu.
• Cartography Setup Menu.
• Presentation softkey (see page
Changes are retained when you power off.
To open the Chart Setup Menu
1. Press the MENU key on the display unit.
2. Highlight Chart Setup.
3. Press the right-arrow on the trackpad.
FUNCTION OPTIONS
Object Information OFF
No info pop-up is displayed but detailed
data can still be displayed by pressing OK.
All ON
Displays an information pop-up for all
objects.
Points ON
Displays an information pop-up for objects
selected with the cursor only.
Vector Length
Specify a time period for drawing 3 Mins
COG and heading vectors. 6 Mins
Infinite
G-Series Reference Manual
63).
46
FUNCTION OPTIONS
Vector Width
Sets the width of the COG and Thin
HEADING chart vector lines. Normal
Wide
Record Vessel Track By Auto
System automatically creates track points.
Time
For track point creation by a specified time.
Distance
For track point creation by a specified
distance.
Track Interval Time
Option availability depends upon Specify time between track points.
Record Vessel Track By setting. 2/5/10/30 seconds
1/3/5/10/30 minutes
Distance
Specify distance between track points.
0.02/0.05/0.1/0.2/0.5/1.0 nm
Datum
See additional information WGS 84.
below. List of datum provided.
Chart Offset
ON
Corrects positional errors in
OFF
cartography.
Datum
The Chart application and your paper charts must use the same
datum to correlate accurately. The default datum for the display is
WGS1984. If that is not suitable, you can change it to one from the
set provided under the Datum option on the Chart Setup menu.