Section 7 − Maintenance & Troubleshooting; Routine Maintenance; Cleaning Debris From Shielding Gas Filter Fitting - Miller FieldPro Smart Feeder CE Owner's Manual

SECTION 7 − MAINTENANCE & TROUBLESHOOTING

7-1. Routine Maintenance

n = Check Z = Change
Every
3
Months
n Z l Replace Damaged
Or Unreadable Labels
n Z l Repair Or
Replace Cracked
Cables And Cords
Every
6
Months
Clean Drive Rolls
n ~

7-2. Cleaning Debris From Shielding Gas Filter Fitting

Rear View
Tools Needed:
3/4 in.
OM-264234 Page 28
~ = Clean l = Replace
1
.
! Disconnect power
before maintaining.
n Z l Replace Damaged Gas Hose
n ~ Blow Out Or
Vacuum Inside
! Disconnect
maintaining.
1 Shielding Gas Filter Fitting
Remove fitting from gas valve on
back panel of feeder.
Blow compressed air through the
threaded male end of fitting to dis-
lodge debris from internal mesh
screen.
.
Replace fitting if blowing com-
pressed air through fitting does
not clear obstructions.
Reinstall fitting into gas valve.
Tighten fitting to 125 in. lbs (22.6 N⋅m).
Maintain more often
during severe conditions.
power before
Ref. TP2 / 805 128-A