Wire Feeder Rear Panel Connections; Optional Gas Flow Meter - Miller FieldPro Smart Feeder CE Owner's Manual

5-8. Wire Feeder Rear Panel Connections

! Turn Off power source and
disconnect both work cables and
electrode cable from feeder.
1 Work Clamp Female Connector
Push work cable male connector into
female connector on feeder and turn 1/4
turn clockwise.
2 Work Cable From Power Source Male
Connector

5-9. Optional Gas Flow Meter

1 Optional Gas Flow Meter
The optional gas flow meter is shown
installed.
OM-264234 Page 18
1 2 3
Push work cable female connector over
male connector on feeder and turn 1/4 turn
clockwise.
3 Electrode Cable From Power Source
Male Connector
Push electrode cable female connector
over male connector on feeder and turn 1/4
turn clockwise.
1 3
2 Gas Inlet On Smart Feeder
Attach flow meter gas hose to gas inlet on
Smart Feeder using 11/16 in. Wrench.
4
4 Shielding Gas Fitting
Connect fitting on end of shielding gas hose
to fitting on feeder.
.
This feeder has an optional shielding
gas filter that requires special attention
when cleaning. See Section 7-2 for
proper cleaning instructions.
2
3 Gas Inlet On Flow Meter
Attach shielding gas supply hose to gas in-
let on flow meter.
262 535-B
265 847-A