Table of Contents
Advertisement
Process
Flux Core/GMAW
Note: Arc Length − Length of arc from end of wire to weld puddle. Wire feed speed and voltage are synergic for the
RMD and Pulse-MIG processes. This means when adjusting wire feed speed, the voltage is automatically adjusted
so it is not necessary to adjust the Arc Length.
*See wire manufacturer for recommended wire feed speed and gas mixture.
6-3. Restoring Factory Defaults
6-4. Viewing Software Revisions
3
OM-264234 Page 26
Flux Core
Wire Size
Rolling Pipe/In Position
in. (mm)
Wire Feed Speed
IPM (mpm)
Not
50-500 w/250 Nominal
Dependent
(1.3-19.8 w/6.4 Nominal)*
3
2
24.5-32 w/25.0 Nominal
1
1
Voltage
Shielding Gas
Not Dependent
1
Smart Feeder Setup Panel
2
Load Button
3
Save Button
To return feeder to factory default set-
tings, press the load and save buttons
simultaneously for more than three
seconds.
The display will show rSt and then go
to dashes when the reset is complete.
264 178-C
1
Smart Feeder Front
Panel
2
MEMORY Button
3
MIG TYPE Button
System Software Revision
Pressing the MIG TYPE and
MEMORY buttons simultane-
ously will display the software
revision.
Circuit Board Software
Revisions
Pressing and releasing the
MEMORY button while holding
the MIG TYPE button in will cy-
cle through software revisions
on the display.
2
264 175-B
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
