Setting The Mmc831 Mgi Parameters; Table 4.4 Mmc831 Parameters - Samsung OfficeServ 500 Service Manual

OfficeServ 500 Wireless LAN Service Manual/Ed.00
2.7

Setting the MMC831 MGI Parameters

This MMC provides a mean to configure the Internet Protocol(IP) addressing of the
MGI card(s). This MMC must be utilized MGI card(s) used on the system.
Number
0
1
2
3
4
5
6
7
Program Buttons
VOLUME
KEYPAD
SOFT BUTTONS Move cursor left and right
SPEAKER
© SAMSUNG Electronics Co., Ltd.

Table 4.4 MMC831 Parameters

Parameters
IP ADDRESS Specifies the IP address for the MGI card.
GATEWAY Specifies the designated IP gateway address used for contacting IP
devices beyond the local subnet.
SUB MASK Specifies the IP subnet mask. This parameter is used by the system to
calculate the range if IP devices(subnet) that are within 'direct reach'
of the MGI(without having to go through the designated network IP
gateway).
PUBLIC IP The MGI will originate communications, to IP phones and VoIP
connections outside the local network, using this IP address. If this
IP address sets 0.0.0.0, 255.255.255.255 or default value then this
MGI card uses private IP only. See System IP Type on MMC 830.
STS PERIOD No entry required. Designates the timed message cycle to check the
remote IP status of MGI3 S/W.
VERSION No entry required. Used to indicate revision of MGI3 S/W.
MAC ADDR For your reference, and cannot be changed. The unique
hardware(MAC)
address of the MGI card.
CARD RESET Prompt to restart MGI card when IP address is changed. This use
for MGI 1 and 2 only, MGI3 is self restart automatically.
A MGI card
This MMC cannot be accessed unless there is a MGI card installed in the system.
Used to scroll through options
Used to enter selections
Used to advance next MMC
CHAPTER 4. MMC Programming
Description
Page 4-17